HEYM USA | email: info@heymusa.com

Barrel Steel being deep-drilled before rifling.	Each barrel is optically inspected for interior finish after lapping.	Finished barrel blanks are inventoried .

Actions are machined from solid steel.	A pair of 600 NE barrel blanks.	Shoe-Lump being wired to barrels in preparation for assembly.

600 NE barrels with Shoe-Lump in place.	Still to be added: top & bottom ribs, quarter-rib & front sight ramp.	Barrel components assembled with wire.

"Nailing" the ribs	Barrel components being soldered together.	Quarter-rib being machined for rear sight.

Barrel, action & all small parts.	All parts serial numbered and prepared to be fitted.	Each part is hand-fit for a perfect fit.

Action & Barrels being hand-fit.	Double Rifle barrels to be fitted.	The almost complete "working end" of a 600 NE.

The stockmaker's "tools of the trade."	Thin-shelled walnut blanks.	"Heading up" the stock takes approximately two-days of hand-fitting.



	Rough-fitted forend.	Rough-shaped stock & forend.

Pin-less sidelock of 600 NE.	Fitting barrels to action.	Scope & mount installation.

Machining the integral 3rd bite.	Hand-fitting ejectors.	Hand-fitting action & forend iron.

88-B Pinless sidelock.	600 Nitro Pin-less sidelock & action.	Drilling barrels being assembled.

Hand-shaping of 470 NE action.	Magnum Mauser in 505 Gibbs.

		Brown bear on Mauser floor plate.

Final inspection of complete rifle.	100-meter undergound regulation range.	Regulation & final shooting.

Bone & charcoal case-colored magnum Mauser action.	Fine-tuning trigger pull.	Complete guns ready to ship.